Audio baby monitor Audiovoice
3020


INFO CENTER

WHICH SECTION ARE YOU INTERESTED IN?

PARENT UNIT (PU) BUTTONS

  1. Lullabies/Timer: press briefly to play lullabies and switch between them. Press and hold to turn the timer on/off.
  2. Volume down button: press (-) to lower the volume.
  3. Charge indicator: red while charging, green when fully charged.
  4. Operating indicator: after switching on, it stays on for 5 seconds. The light stays on when connected and flashes when disconnected.
  5. Sound level LED: indicates the low/high sound level detected by the baby unit.
  6. Volume up button: press (+) to increase the volume.
  7. Two-way communication: press and hold to talk to the baby.
  8. Speaker
  9. Microphone
  10. Power button: press and hold to turn the device on/off. Press briefly to deactivate the lullabies.
  11. Charging port

BABY UNIT (BU) BUTTONS

  1. Lullabies/Timer: press briefly to play lullabies and switch between them. Press and hold to turn the timer on/off.
  2. Volume down button: press (-) to lower the volume.
  3. Charge indicator: red while charging, green when fully charged.
  4. Operating indicator: after switching on, it stays on for 5 seconds. Stays on if connected; flashes rapidly if disconnected.
  5. 30-minute timer indicator: press and hold the music button once to activate the 30-minute timer. After 30 minutes of playback, the music stops and the indicator turns off. The indicator flashes when the battery is low.
  6. 60-minute timer indicator: press and hold the music button twice to activate the 60-minute timer. After 60 minutes of playback, the music stops and the indicator turns off.
  7. Volume up button: press (+) to increase the volume.
  8. Speaker
  9. Microphone
  10. Power button: press and hold to turn the device on or off. Press briefly to deactivate the lullabies.
  11. Charging port

TURNING ON / OFF


▶️ Press the power button (10) for 3 seconds to turn the device on; you will hear a "Power On" beep.
▶️ When the device is on, press the power button (10) for 3 seconds to turn it off; you will hear a "Power Off" beep.

The turning on and off procedure is the same for both the baby unit and the parent unit.

SOUND ADJUSTMENT


The "volume up" button increases the sound of the lullabies and the intercom, while the "volume down" button decreases the sound of the lullabies and the intercom.

There are 5 volume levels for both the parent unit and the baby unit. A beep is emitted when the volume is decreased or increased to the minimum/maximum.

The procedure for raising or lowering the volume is the same for both the baby unit and the parent unit.

HOW TO SET A LULLABY


▶️ Press the lullaby button (1) to start the lullaby and press it again to change the melody.
▶️ Press 6 times to play the 5 available lullabies one after another.
▶️ During music playback, briefly press the power button (10) to stop it.

The music is played on the baby unit only (BU). The parent unit (PU) can remotely control playback on the baby unit (BU).

HOW TO SET A LULLABY TIMER

For both units (PU, BU), press and hold the lullaby button (1) for 3 seconds to activate the 30-minute timer and press and hold it again to activate the 60-minute timer.

Press and hold a third time to deactivate the timer.

HOW TO COMMUNICATE WITH YOUR BABY


▶️ Press and hold button (7) on the parent unit to communicate with your baby.
▶️ Release it to exit two-way talk-back mode and end the communication.

HOW TO SET A LULLABY TIMER

For both units (PU, BU), press and hold the lullaby button (1) for 3 seconds to activate the 30-minute timer and press and hold it again to activate the 60-minute timer.

Press and hold a third time to deactivate the timer.

FREQUENTLY ASKED QUESTIONS

Why is the device not responding normally?

If the device is not responding normally, check whether the battery is low. Restart the device and wait one minute.

Why is the device producing a high-pitched noise?

If the device is producing a high-pitched noise, the units may be too close to each other. Make sure the parent unit and the baby unit are more than 1 m apart from each other

Why does the connection drop or audio interruptions occur from time to time?

If the connection drops from time to time or audio interruptions occur, there may be other electronic devices causing interference with the baby unit.

Try installing the baby unit as far away as possible from these electronic devices.
Didn't find what you were looking for? SEND YOUR REQUEST

YOUR CART (0)

No Products in the Cart